TAU S.r.l. 24Vdc Gearmotor Sliding Gate Drive (230Vac powered) with optical encoder, built-in 500K126MA control board, with battery charger.
Suited to Ground Track gates running near level up to 1200 kgs and free rolling Cantilever gates up to 900 kgs.
Intensive use - 100% duty cycle when connected to 230Vac power source
Opening speed - 400 mm/sec
Closing speed – 233 or 400 mm/sec
Low voltage DC Gate Drive
Optical encoder technology (no limit switches required)
Control board protected within a plastic enclosure
Practical manual release with a personal key
Controlled by the K126MA Diamond series auto-adaptive algorithm Control Board with the following features
Built-in 3 channel 433.92 Mhz rolling-code radio receiver
Built-in battery charger for power outage back-up battery operation
Electronic obstacle detection and crush prevention. EN 12445/12453 standards
Soft start and soft stop
- 8 stage mechanical gate health via tri-colour diagnostic LEDs.
- 20 point flashing error tri-colour diagnostic LEDs for obstacle detection, motor over current, encoder health, low battery, plus more
Off Grid Solar Charge capable thanks to Photovoltaic (PV) Technology
Technical features
500MASTER-RAPID
Power supply (to control unit)
230 V AC (50 - 60 Hz)
Motor power supply
24 V DC
Motor Absorption
1.8 A (no load)
Absorbed power
360 W
Max. opening speed
400mm/sec
Max. closing speed
233 or 400mm/sec
Duty cycle
100 %
Max. thrust
1300 N
Operating temperature
-20° C ÷ +55° C
Degree of protection
IP 54
Max. gate leaf weight
1200 kg
Pinion module
Module 4
Electronic Control Unit
K126MA
PLEASE NOTE: Safety First
The specifications and suggested gate sizes will vary depending upon other variables such as friction of wheels, environmental factors e.g. wind loading, type of cladding and external influences which may assist or degrade the recommended gate sizes.
All automation applications require external safety photocell protection / vehicle loop detector and appropriate warning signs and/or devices.
MAINTENANCE: To keep your Automated Gate running smoothly READ MORE NOW > to learn more on Safety and the Maintenance required to keep your Automated Gate running smoothly.
TAU 500MASTER-RAPID 24V Sliding Gate Drive
TAU S.r.l. 24Vdc Gearmotor Sliding Gate Drive (230Vac powered) with optical encoder, built-in 500K126MA control board, with battery charger.
Suited to Ground Track gates running near level up to 1200 kgs and free rolling Cantilever gates up to 900 kgs.
Controlled by the K126MA Diamond series auto-adaptive algorithm Control Board with the following features
PLEASE NOTE: Safety First
The specifications and suggested gate sizes will vary depending upon other variables such as friction of wheels, environmental factors e.g. wind loading, type of cladding and external influences which may assist or degrade the recommended gate sizes.
All automation applications require external safety photocell protection / vehicle loop detector and appropriate warning signs and/or devices.
MAINTENANCE: To keep your Automated Gate running smoothly
READ MORE NOW > to learn more on Safety and the Maintenance required to keep your Automated Gate running smoothly.
> Downloads